2009 Toyota Camry Oil Type and Capacity (Exact Specs)

By the CarsDailyHub Editorial Team | Automotive writers; every article fact-checked against Toyota’s owner’s manual and OEM service documentation | Updated June 2026

Quick Answer: The 2009 Toyota Camry with the 2.4L four-cylinder (2AZ-FE) takes about 4.5 US quarts of 5W-30 with a filter change. The 3.5L V6 (2GR-FE) takes about 6.4 US quarts of 5W-30. The 2.4L Hybrid uses about 4.4 quarts. Toyota later approved 0W-20 synthetic for the four-cylinder for better economy and cold starts. Always verify against your specific owner’s manual and the oil-cap marking.

This guide covers engine oil specifications for the 2009 Toyota Camry (2.4L 2AZ-FE, 3.5L 2GR-FE V6, and 2.4L Hybrid). Last reviewed: June 2026.

2009 Camry Oil Specs by Engine
Oil Type and Viscosity Explained
Oil Filter Information
How Often to Change the Oil
How to Change the Oil (Quick Steps)
Frequently Asked Questions
Sources & References

2009 Camry Oil Specs by Engine

Engine	Oil Capacity (with filter)	Recommended Viscosity	Oil Type
2.4L I4 (2AZ-FE)	~4.5 US qt (4.3 L)	5W-30 (0W-20 later approved)	Synthetic or synthetic blend
3.5L V6 (2GR-FE)	~6.4 US qt (6.1 L)	5W-30	Synthetic or synthetic blend
2.4L Hybrid (2AZ-FXE)	~4.4 US qt (4.2 L)	5W-30 (0W-20 later approved)	Synthetic recommended

Capacities are approximate and assume the oil filter is replaced. Always fill to the dipstick mark rather than relying solely on a quoted capacity, and check the oil-fill cap, which is often stamped with the recommended viscosity.

Oil Type and Viscosity Explained

For 2009, Toyota specified 5W-30 for the Camry’s engines. The “5W” describes cold-start flow (lower is better in cold weather) and the “30” describes thickness at operating temperature. Toyota later expanded its approval to 0W-20 for the four-cylinder engines, which improves cold-start protection and fuel economy slightly; if you use 0W-20, use a full synthetic.

You do not have to run full synthetic in a 2009 Camry, but it is a worthwhile upgrade: synthetic resists breakdown and sludge better, which matters because the 2AZ-FE four-cylinder of this era had a known history of oil consumption on some examples. Clean, correct-viscosity oil changed on time is the best defense.

Oil Filter Information

2.4L four-cylinder: uses a spin-on oil filter (common Toyota part numbers include 90915-YZZF2 / 90915-YZZD1, or an equivalent from a reputable brand).
3.5L V6: uses a cartridge-style filter (Toyota 04152-YZZA1 or equivalent), housed in a cap on the front of the engine; replace the housing O-ring with each change.

Always match the filter to your specific engine, and use a quality filter, a cheap filter is false economy on an engine you want to keep clean.

How Often to Change the Oil

Toyota’s guidance for this era moved toward longer intervals with synthetic oil, but real-world advice depends on use:

Synthetic oil: roughly every 7,500 to 10,000 miles under normal conditions.
Conventional or blend: closer to every 5,000 miles.
Severe service (short trips, extreme heat or cold, heavy idling, dusty conditions): change more often, around every 5,000 miles regardless of oil type.

Given the 2AZ-FE’s oil-consumption reputation, check the oil level regularly between changes on the four-cylinder, and top up promptly if it is low.

How to Change the Oil (Quick Steps)

Warm the engine briefly so the oil drains well, then shut it off.
Raise and safely support the front of the car.
Place a drain pan, remove the drain plug, and let the oil drain fully.
Replace the oil filter (spin-on for the four-cylinder; cartridge and O-ring for the V6).
Reinstall the drain plug with a new crush washer and torque it to spec, do not overtighten.
Refill with the correct amount and viscosity, then check the dipstick.
Run the engine, check for leaks, then recheck the level after it settles.
Reset the maintenance reminder if equipped, and record the mileage.

Frequently Asked Questions

Q: How much oil does a 2009 Toyota Camry take?
A: The 2.4L four-cylinder takes about 4.5 US quarts with a filter change, and the 3.5L V6 takes about 6.4 US quarts. The 2.4L Hybrid takes around 4.4 quarts. These are approximate, so always fill to the dipstick mark rather than pouring in an exact quoted figure, and verify against your owner’s manual.

Q: What kind of oil does a 2009 Camry use?
A: Toyota specified 5W-30 for the 2009 Camry, and later approved 0W-20 (full synthetic) for the four-cylinder engines for better economy and cold-start protection. A full synthetic 5W-30 or approved 0W-20 is a good choice, especially given the four-cylinder’s history of oil consumption, since synthetic resists breakdown and sludge better.

Q: Can I use 0W-20 instead of 5W-30 in my 2009 Camry?
A: For the four-cylinder, Toyota later approved 0W-20 synthetic, so it is acceptable and can slightly improve fuel economy and cold starts. For the V6, stick with the specified 5W-30 unless your manual states otherwise. Whenever you switch to a thinner oil, use a full synthetic and monitor your oil level, especially on a higher-mileage four-cylinder.

Q: Why does my 2009 Camry 2.4L burn oil?
A: The 2AZ-FE four-cylinder of this era is known on some examples for elevated oil consumption, often related to piston ring design and deposits. The practical response is to check the oil level regularly between changes, top up when low, use a quality synthetic, and keep up with changes. Severe consumption may need a piston-ring or related repair, which Toyota addressed for some vehicles.

Q: How often should I change the oil in a 2009 Camry?
A: With full synthetic, roughly every 7,500 to 10,000 miles under normal driving; with conventional or a blend, closer to every 5,000 miles. Under severe service, short trips, extreme temperatures, or dusty conditions, change it around every 5,000 miles. On the four-cylinder, check the level between changes because of the oil-consumption tendency.

Sources & References

Toyota Motor Corporation, 2009 Toyota Camry Owner’s Manual and Warranty/Maintenance Guide
Toyota service information for 2AZ-FE, 2GR-FE, and 2AZ-FXE engines
Toyota guidance on approved oil viscosities (5W-30 and 0W-20)
Toyota filter part references and oil-consumption service communications